Washington HVAC
-
Continuing Education is not required at this time. However, the following courses are based on subject matter approved in most states to fulfill continuing education requirements for General Contractors. These courses will be beneficial to your industry.
Air Conditioning/Refrigeration Laws and Rules
2 hours for $20.00 online!
2 hours for $20.00 online!
This 2-hour course satisfies the State Rules requirements for Air Conditioning / Refrigeration Contractors.
2003 International Mechanical Code Review
2 hours for $20.00 online!
2 hours for $20.00 online!
This 2-hour course is a review of commonly-used codes in the 2003 IMC.
Manual J Residential Calculations
2 hours for $20.00 online!
2 hours for $20.00 online!
This 2-hour course covers A/C load calculations for residential buildings using the Manual J.
Manual N Commercial Calculations
1 hour for $10.00 online!
1 hour for $10.00 online!
This 1-hour course covers A/C load calculations for commercial buildings using the Manual N.
Using the ACCA Duct Slide Rule
1 hour for $10.00 online!
1 hour for $10.00 online!
This 1-hour course covers duct sizing and system design using the ACCA Duct Slide Rule.
Our online instruction system is the easiest possible way to earn your CE credits. Your progress through the course is recorded in our servers, allowing you to work at your own pace.
You may choose to work through the course a little at a time; when you return to www.ceforwashington.com and enter your email address and password, you will be taken to the point in the course where you left off.
Check out these references!
2007 National Plumbing & HVAC Estimator
